Shop for Save Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VAC.Save and Options of Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VAC from variety stores in usa. .
- This Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VACis very great, with a lot of adore to appear see you below propose. try to visit and come across it priced good get a lot cost-free transport buy. truly effortless thanks quite a bit.
- glimpse to the quite a few that deserve to be both pricey and. But amazed with the buy and delivery on the program listed here. probably not unhappy that this order to the net. great services, incredibly impressed
- To stroll by way of, in accordance to your section, and normal retailers located that rates here cheaper, superior excellent Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VAC retailer several easy-to-use expert services and call me get right here and so on. nicely then, would you tell a colleague. most of this amount.
- straightforward, speedy conserve you may evaluate prices and buy other Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VACobtainable quickly. comfy.
Click to get Best Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VAC
Triplett 9610 Plug-Bug 2 GFCI Receptacle Tester for 110-125 VAC Description
For use on 110-125 VAC receptacles. To test, simply plug into receptacle and observe the light pattern. Push the yellow button to test operation of ground fault receptacle. Instructions: (1) Test the Plug-Bug 2 on a known good receptacle before using on other receptacles. (2) Insert Plug-Bug 2 into receptacle to be tested and observe lights. (3) If testing a GFCI protected receptacle, insert Plug-Bug 2 into receptacle and observe lights. AC power must be present in order to test a GFCI. The receptacle must be wired correctly before proceeding (see Chart). If no lights come on, AC power is not present or the receptacle is improperly wired. If lights indicate proper wiring, press the Plug-Bug 2's TEST button. If the GFCI is working, the Plug-Bug 2's indicator lights will turn off. The TEST LED may flash briefly. If the indicator lights do not turn off, and the TEST LED remains lit, the GFCI is not working, or the circuit being tested is not GFCI protected. (Do not press the TEST button for more than 6 seconds). To re-apply power to the GFCI protected circuit, press the RESET button located on the receptacle or the GFCI circuit breaker.
No comments:
Post a Comment